PCB for 1590BB enclosure (horizontal)

This board simplifies building your DIY guitar pedal in a 1590BB enclosure. With the LEDs, jacks, and footswitches mounted directly to the board, you only need to wire the battery and the effect PCB.
Steps
  1. Overview
  2. Designators and components
  3. PCB assembly
  4. Wiring
  5. Drilling template
  6. Example: Les Lius
  7. Example: Box of Rock
  8. Example: Biff Muff + Boost
  9. Example: Full Drive
  10. Example: Centaur Overdrive
  11. Example: Overdrive + Boost
  12. Example: Amp Eleven
Categories
Tayda Electronics Kits, DIY Projects, DIY Guitar Effects
Created by DHEA
Status: Active
6ad5cfedb16d6a272994ad5c2b2b82c7?s=30

Example: Overdrive + Boost Step 11 of 12

Add a booster (SUPER HARD ON, LINEAR POWER BOOSTER, STRATOBLASTER, JFET PREAMP, MICRO AMP...) after any overdrive or distortion effect (RAT, ETERNITY, TUBE SCREAMER, OCD...).

Next Page >>
<< Prev Page