PCB for 1590BB enclosure (horizontal)

This board will help to build your DIY guitar pedal in the 1590BB enclosure. Led, jacks and footswitch are mounted on the PCB, being only necessary to wire the battery and the effect PCB.
Steps
  1. Overview
  2. Designators and components
  3. PCB assembly
  4. Wiring
  5. Drilling template
  6. Example: Les Lius
  7. Example: Box of Rock
  8. Example: Biff Muff + Boost
  9. Example: Full Drive
  10. Example: Centaur Overdrive
  11. Example: Overdrive + Boost
  12. Example: Amp Eleven
Categories
Tayda Electronics Kits, DIY Projects, DIY Guitar Effects
Created by DHEA
Status: Active
6ad5cfedb16d6a272994ad5c2b2b82c7?s=30

Drilling template Step 5 of 12

Choose an enclosure (www.taydaelectronics.com/hardware/enclosures.html), use the drill service (www.taydaelectronics.com/hardware/enclosures/enclosure-custom-drill-service.html) and the UV printing service (www.taydaelectronics.com/hardware/enclosures/enclosure-uv-printing-service.html).

 

Adjust the diameter of hole #3 for the DC connector (9 mm works for most of the connectors).

Adjust the diameter of hole #5 for the LED as follows (for painted enclosures):

  • 3 mm LED: 3.2 mm
  • 3 mm LED metal holder: 6 mm
  • 5 mm LED: 5.2 mm
  • 5 mm transparent holder: 6.5 mm

Next Page >>
<< Prev Page