PCB for 1590BB enclosure (horizontal)

This board simplifies building your DIY guitar pedal in a 1590BB enclosure. With the LEDs, jacks, and footswitches mounted directly to the board, you only need to wire the battery and the effect PCB.
Steps
  1. Overview
  2. Designators and components
  3. PCB assembly
  4. Wiring
  5. Drilling template
  6. Example: Les Lius
  7. Example: Box of Rock
  8. Example: Biff Muff + Boost
  9. Example: Full Drive
  10. Example: Centaur Overdrive
  11. Example: Overdrive + Boost
  12. Example: Amp Eleven
Categories
Tayda Electronics Kits, DIY Projects, DIY Guitar Effects
Created by DHEA
Status: Active
6ad5cfedb16d6a272994ad5c2b2b82c7?s=30

PCB for 1590BB enclosure (horizontal) Step 1 of 12

Dhd8_1

This board simplifies building your DIY guitar pedal in a 1590BB enclosure. With the LEDs, jacks, and footswitches mounted directly to the board, you only need to wire the battery and the effect PCB. The board also includes built-in power supply filtering and reverse polarity protection, and it supports both single and dual effects with various switching configurations.

 

The PCB supports several switching configurations:

Individual Effects: The right and left footswitches independently control their respective effects.

 

Nested Effects: The right footswitch controls the overall bypass. The left effect is only active when the right footswitch is engaged. This is ideal for using a boost after an overdrive or distortion pedal.

 

Single Effect (Right Footswitch): Use this configuration for a single effect unit in a 1590BB enclosure, with control on the right side.

 

Single Effect (Left Footswitch): Use this configuration for a single effect unit in a 1590BB enclosure, with control on the left side.

 

Single Effect with SPDT Switch: The right footswitch bypasses the effect, while the left footswitch controls a SPDT switch. This is perfect for switching between diodes, different tones, or a boost.

 

Check Out The Forum

Next Page >>