Arduino PID Controller Shield

This easy-to-make shield converts your Arduino into a full-featured PID controller.
Steps
  1. Overview
  2. Arduino Board
  3. Prepare stripboard
  4. Pin headers
  5. Jumper wires
  6. Resistors
  7. Add components
  8. Check layout
  9. Create probes
  10. Label switches
  11. Upload firmware
  12. Install serial interface
  13. Demo
  14. Materials
  15. Resources
Categories
DIY Projects, Arduino Projects
Created by Magic Smoke
Status: Active
25fbd9e3f998b27136e5f97c83f103b1?s=30

Resistors Step 6 of 15

Solder the axial resistors in place. This should be easy after the practice you have had soldering the jumpers! The resistor values are: R1, R2, R4, R7: 1 KΩ. R3: 10 KΩ. R5, R8: 330 Ω. R6: 470 Ω.

 

Next Page >>
<< Prev Page

Products