Arduino PID Controller Shield
This easy-to-make shield converts your Arduino into a full-featured PID controller.Steps
Categories
Created by Magic Smoke
Status: Active
Status: Active
Materials Step 14 of 15
These are the Tayda components that you will need for this project:
- 93x53mm stripboard (copper)
- 16x2 character LCD display with blue backlight
- PCB mount piezoelectric buzzer
- 4 x tactile switch
- DS18B20 digital temperature sensor
- 10 KΩ NTC thermistor
- screw terminal block 5mm pitch, 3 positions
- screw terminal block 5mm pitch, 2 positions
- 0.1" pitch male pin header strip
- 0.1" pitch female pin header strip
- 2N3904 transistor
- 10 KΩ trimpot
- 2x 5mm red LED
- 5mm yellow LED
- 10 x 10 KΩ resistor 1%
- 10 x 330 Ω resistor 5%
- 10 x 470 Ω resistor 5%
- 10 x 1 KΩ resistor 5%
- 10 x 4.7 KΩ resistor 5%
- 10 x 0.1 uF ceramic capacitor
- 1' black 22 AWG solid hook-up wire
- 1' red 22 AWG solid hook-up wire
- 1' yellow 22 AWG solid hook-up wire
- 6' red 22 AWG stranded hook-up wire
- 6' black 22 AWG stranded hook-up wire
- 3' yellow 22 AWG stranded hook-up wire
You may also need some of the following tools. Soldering is much easier with a temperature controlled soldering station. For safety reasons, I recommend using lead free solder.
