Arduino PID Controller Shield

This easy-to-make shield converts your Arduino into a full-featured PID controller.
Steps
  1. Overview
  2. Arduino Board
  3. Prepare stripboard
  4. Pin headers
  5. Jumper wires
  6. Resistors
  7. Add components
  8. Check layout
  9. Create probes
  10. Label switches
  11. Upload firmware
  12. Install serial interface
  13. Demo
  14. Materials
  15. Resources
Categories
DIY Projects, Arduino Projects
Created by Magic Smoke
Status: Active
25fbd9e3f998b27136e5f97c83f103b1?s=30

Prepare stripboard Step 3 of 15

Clean the stripboard with isopropyl alcohol to remove grease and tarnish. Orient the board with one long side to the front and the copper tracks on the top. Cut tracks in the positions shown on the diagram below using a 1/8" drill bit or craft knife. It's a good idea to check with the continuity tester setting on your multimeter. Check the locations carefully — I made a couple of extra holes by mistake which I had to correct later on by bridging the holes with the cut-off leg from a LED.

 

Next Page >>
<< Prev Page

Products