PCB for 1590B enclosure
This board will definitely help you to build your DIY guitar pedal in the 1590B enclosure. Led, jacks and footswitch are mounted on the PCB, being only necessary to wire the battery and the effect PCB.Steps
Categories
Created by DHEA
Status: Active
Status: Active
Wiring Step 5 of 5
To connect the 1590B enclosure PCB and the effect PCB you can use a 4 pin connector or solder the cables as indicated in the following figure. The PCB pins are marked as "GND" ,"+V", "FROM FX" and "TO FX". Connect "FROM FX" to the output of the effect PCB, and "TO FX" to the input of the effect PCB.