Charge Pump

This versatile charge pump generates both –9 V and +18 V from a single +9 V power source.
Steps
  1. Overview
  2. Designators and components
  3. PCB assembly
  4. Enclosure and wiring
Categories
DIY Projects, DIY Guitar Effects
Created by DHEA
Status: Active
6ad5cfedb16d6a272994ad5c2b2b82c7?s=30

Enclosure and wiring Step 4 of 4

ASSEMBLING

Place the assembled PCB inside the pedal enclosure with the main effect PCB and the rest of components. Use an ADHESIVE holder to secure the PCB in place.

 

WIRING

Use a 24 AWG stranded wire to connect all components as shown in the following figure. The figure below shows the wiring for a negative-tip DC connector.

WIRING FOR -9V OUTPUT

 

WIRING FOR +18V OUTPUT

<< Prev Page