Treble Booster Brian May

This treble booster is a classic DIY project. Use it to boost the treble and midrange frequencies of the guitar signal while cutting out the low end.
Steps

Created by DHEA
Status: Active
6ad5cfedb16d6a272994ad5c2b2b82c7?s=30

Enclosure drilling Step 5 of 5

Choose an enclosure and use the custom drilling service. For personalized artwork, use the UV printing service. Open this drilling template or add the coordenates from the following table into the online tool at drill.taydakits.com. The holes #1 to #5 are for the 1590B enclosure PCB.

 

Adjust the diameter of hole #3 for the DC connector (9 mm works for most of the connectors).

Adjust the diameter of hole #5 for the LED as follows (for painted enclosures):

  • 3 mm LED: 3.2 mm
  • 3 mm LED metal holder: 6 mm
  • 5 mm LED: 5.2 mm
  • 5 mm transparent holder: 6.5 mm