PCB for 1590BB enclosure

This PCB simplifies building your DIY guitar pedal in a 1590BB enclosure. With the LED, jacks, and footswitch mounted directly to the board, you only need to wire the battery and the effect PCB.
Steps
  1. Overview
  2. Designators and components
  3. Enclosure
  4. PCB assembly
  5. Wiring
Categories
DIY Projects, DIY Guitar Effects
Created by DHEA
Status: Active
6ad5cfedb16d6a272994ad5c2b2b82c7?s=30

Wiring Step 5 of 5

To connect the 1590BB PCB to the effect PCB, use an XH 4-pin male connector on the 125B board and an XH 4-pin female connector with wires soldered to the effect PCB. Alternatively, you can solder the wires directly, as shown in the figure below.

The PCB pins are labeled as "GND", "+V", "FROM FX", and "TO FX". Connect the "FROM FX" pin to the output of the effect PCB and the "TO FX" pin to the input of the effect PCB.

<< Prev Page